The Truth about Lane Widths

Pedestrian and Bicycle Information Center (PBIC)


The competition for space within a roadway right-of-way is fierce. Not only do sidewalks and bicycle lanes battle motor vehicle lanes for space, but drainage and utilities also vie for their share of the right-of-way. Money for additional right-of-way is hard to find; and adjacent property owners are not usually friendly sellers of land for roadway projects. Often, something gets squeezed out — and usually, it is the bicycle and/or the pedestrian facilities.


When faced with having bicycle lanes, and possibly sidewalks, eliminated from a roadway project, advocates for bicycle and pedestrian facilities may ask, "Can't we narrow the travel lanes to less than 12 feet?" Very likely, the engineers will list apparently good reasons for not wanting to reduce the travel lane widths: 12-foot lanes are the American Association of State Highway and Transportation Officials (AASHTO) standard; reducing lane widths reduces safety; narrowing lane widths reduces the roadway capacity. Surely, given these so-called facts, no one would seriously suggest narrowing lanes.

But what if these facts aren't true? What if we could narrow the lanes on a roadway without adversely impacting the operations of the roadway? These questions have been asked and, in large part, answered. The following is The Truth about Lane Widths.


What is the standard?

The AASHTO "Green Book" (2004) is a guide. On the first page of its foreword it states, "The intent of this policy is to provide guidance ..." Many states, however, have adopted the values in the Green Book as standards. When using its specified values for design criteria, one must keep in mind two other statements from the Green Book's foreword:

Minimum values are either given or implied by the lower value in a given range of values. The larger values ... will normally be used where the social, economic, and environmental (S.E.E.) impacts are not critical. (p. xliii)

With these fundamentals in mind, let's review the actual lane width guidance for urban arterial streets.

According to the Green Book, for rural and urban arterials lane widths may vary from 10 to 12 feet. It goes on to say that 12-foot lanes should be used where practical on higher speed, free flowing, principal arterials. However, under interrupted-flow (roads with signals) conditions operating at low speeds (45 mph or less) narrower lane widths are normally quite adequate and have some advantages (p. 473).

Given these statements from AASHTO, 10-foot lanes should be considered the minimum standard.

What about safety?

Safety is another reason frequently cited for maintaining 12-foot lane widths. However, much research has been performed evaluating the crash impacts of narrowing lanes. This research found little to no support for the safety argument with respect to urban roadways. Some of this research is summarized below.

Effective Utilization of Street Width on Urban Arterials (Harwood, 1990), in its implementation guidelines states, "Narrower lane widths (less than 11 ft) can be used effectively in urban arterial street improvement projects where the additional space can be used to relieve traffic congestion or address specific accident patterns."

It goes on to note that, "... all projects evaluated during the study that consisted exclusively of lane widths of 10 feet or more resulted in accident rates that were either reduced or unchanged" and recommends, "Where streets cannot be widened, highway agencies should give strong consideration to the use of 10-ft lanes where they are necessary as part of a geometric improvement to improve traffic operations or alleviate specific accident patterns." (pp. 31-32)

Most recently, Potts, Harwood, and Richard (2007) reported:

"A safety evaluation of lane widths for arterial roadway segments found no indication, except in limited cases, that the use of narrower lanes increases crash frequencies. The lane width effects in the analyses conducted were generally either not statistically significant or indicated that narrower lanes were associated with lower rather than higher crash frequencies. There were limited exceptions to this general finding [emphasis added]."

This report went on to say:

"The research found three situations in which the observed lane width effect was inconsistent — increasing crash frequency with decreasing lane width in one state and the opposite effect in another state. These three situations are:

  • "lane widths of 3.0 m (10 ft) or less on four-lane undivided arterials.
  • "lane widths of 2.7 m (9 ft) or less on four-lane divided arterials.
  • "lane width of 3.0 m (10 ft) or less on approaches to four-leg STOP-controlled arterial intersections.

"Because of the inconsistent findings mentioned above, it should not be inferred that the use of narrower lanes must be avoided in these situations. Rather, it is recommended that narrower lane widths be used cautiously in these situations unless local experience indicates otherwise." (p. 25)

Based on this research, it appears that narrowing lanes to less than the "standard" 12-foot width does not usually degrade safety.

What about capacity?

The Highway Capacity Manual (HCM) is the primary document used by planners and engineers to determine the capacity of roadways and intersections. In Chapter 16, pages 16-10 and 16-11, the HCM describes factors which impact the capacity of signalized intersections — including an adjustment factor based upon lane widths. The HCM shows that the saturation flow rate (capacity) of a lane at a signalized intersection is reduced by 3.33 percent for each foot of lane width less than 12 feet. Consequently, according to the HCM, the capacity of a 10-foot lane is only 93 percent of the capacity of a 12-foot lane (Transportation Research Board, 2000).

However, in 2007 a literature search was performed as part of the Florida Department of Transportation Conserve By Bike Program Study, to evaluate findings of recent research from across the United States on impacts to urban street capacity resulting from lane narrowings. The search found:

"The measured saturation flow rates are similar for lane widths between 10 feet and 12 feet. For lane widths below 10 feet, there is a measurable decrease in saturation flow rate. Thus, so long as all other geometric and traffic signalization conditions remain constant, there is no measurable decrease in urban street capacity when through lane widths are narrowed from 12 feet to 10 feet [emphasis added]." (Appendix A-P, p. A152)

Capacity, therefore, is not degraded until lane widths are reduced to less than 10 feet.


Before and after photos of 1st Avenue North at 49th Street in St. Petersburg, Florida. General travel lanes were narrowed to 10 feet to provide space for bike lanes. Image: Michael Frederick

In general safety and capacity are not adversely impacted by reducing lanes widths to as little as 10 feet. If we refer back to the AASHTO Green Book's foreword and ask, "Are there critical social, environmental and economic reasons that would justify using less than 12-foot lanes?", the answer, in urban areas, is often "yes."

Accommodating pedestrians and bicyclists is a critical social issue: it makes downtowns more livable, transit more viable, and provides for the mobility of those who cannot, or chose not to, drive. Accommodating more users in less space also addresses critical environmental issues: narrower lanes mean less pavement (asphalt or concrete), less runoff, less land consumed. Narrower lane widths reduce costs, a critical issue in times of shrinking budgets: smaller right-of-way costs, reduced costs for utility easements, reduced construction costs, reduced environmental mitigation costs.

In addition to these obvious considerations, reducing lane widths and providing for the mobility of all transportation system users will decrease motor vehicle emissions and dependence on fossil fuels. Furthermore, increased walking and bicycling resulting from the provision of facilities will promote active lifestyles, help combat the obesity epidemic, and contribute to healthier, more active communities. Realizing the truth about lane widths provides benefits for everyone.


American Association of State Highway and Transportation Officials. (2004). A policy on geometric design of highways and streets (5th ed.). Washington, DC: AASHTO.

Florida Department of Transportation (2007). Appendix A-P and Appendix Q. Conserve By Bicycle Program Study Final Report. Tallahassee, FL: FDOT.

Harwood, D.W. (1990). Effective utilization of street width on urban arterials (NCHRP Report 330). Washington, DC: Transportation Research Board.

Potts, I.B., Harwood, D.W., & Richard, K.R. (2007). Relationship of lane width to safety for urban and suburban arterials. Geometric design and the effects on traffic operations 2007, 63-82. Washington, DC: Transportation Research Board.

Transportation Research Board. (2000). Highway Capacity Manual. Washington, DC: Transportation Research Board.


Theodore A. Petritsch, P.E., PTOE
Senior Transportation Engineer
Sprinkle Consulting, Inc.
18115 US Hwy 41 N, Suite 600
Lutz, FL 33549
(813) 949.7449

Image source

Michael Frederick

Filed in: Engineering, Crashes and Safety, Case Studies

Back to Search Results